Operation; Se Le Cting Syner Gic Pr Ograms - NURIS LN 350 Operational Manual

08/2022 Rev. 1.1

Make sure that the dust and dirt that can get into the machine are kept
at minimum.

Cables should not be stacked on top of each other, cables and machine
should be on the same side of the operator and as far away from the
operator as possible. Cables should not be around the operator and
scattered around.

The gas cylinder should be away from the welding area, should not get
hot and should not be affected by welding sparks .

The machine should not be placed near electromagnetic devices during
operation and storage.

The machine should not be placed in places with a slope of more than
10°. Make sure that the machine is stable before use.

4. OPERATION

4.1. S EL ECT I NG S YNER GI C PR OGR A M S
Synergic programs can be used in two ways: manual (selecting from the list)
and automatic (according to the material to be welded, type of welding wire
and gas type).
Figure 3. Control Panel
6