Storage And Installation; Storage And Operation Environment; Transportation - NURIS MIG 550 RWS Operational Manual

08/2022 Rev. 1.3
The welding wire is stretched from the 1st guide shown in Figure 5.4 and driven onto
the wire reel. The wire passed through the guide is inserted into the wire drive reel
channel as shown in Figure 5.4-2. The wire passed through the reels is passed through
the direction guide as in Figure 5.4-3, and the manual driving process is completed.
After the manual driving process is completed, overprints are closed(Figure 5.4-4). By
pressing the wire feed button, the wire is fed until the wire comes out homogeneously
from the tip of the torch.
If the pressure setting is too high, crushing may occur on the wire. The
round structure of the wire may be disrupted and problems may occur
while passing through the torch. In addition, the problem of clogging
in the contact nozzle may be encountered. If the pressure is low, the
wire will be loose and the wire feeding will not be homogeneous. When
adjusting the pressure, it is done from loose to tight.

3.STORAGE AND INSTALLATION

3.1. STORAGE AND OPERATIO N ENVIRONMENT

The machine should be stored in a closed and dry environment between -30
o
and +55 C.

It should be kept upright and nothing should be put on it.

Operating temperature must be between -25
operated in a dry environment.

Make sure that the machine can breathe easily while working.

Dirt and dust in the environment should be at minimum.

3.2. TRANSPORTATION


Always use the handles when moving the machine.

Never pull on cables, torch or hoses.

Before moving make sure that the machine is turned off and disconnected from
the grid.

Before transporting, remove all interconnections.

Gas cylinders and small parts must be transported separately from the machine.
Figure 5.4. Wire Feed System
6
o o
C and +40 C and it should be
o
C