Err Or Messages And Meanings - NURIS LN 350 Operational Manual

5.3.1. ER R OR M ES S A GES A ND M EA NI NGS
ERROR
MESSAGE
High temperature of
E- 3001
IGBT
High temperature of
E- 3002
Diode
Welding output high
E- 3003
voltage
Welding output high
E- 3004
current
E- 3005 Electricity phase error
E- 3006 Current sensor fault
5V sensor supply low
E- 3007
voltage
5V sensor supply high
E- 3008
voltage
Open circuit of IGBT
E- 3009
sensor
Short circuit of IGBT
E- 3010
sensor
Open circuit of diode
E- 3011
sensor
Short circuit of diode
E- 3012
sensor
MEANING
15
WHAT TO DO
Welding should be stopped and the
machine should be allowed to
cool. Welding should be done at
lower regime. However, if the
error message recurs, contact the
authorized service.
Welding should be stopped and the
machine should be allowed to
cool. Welding should be done at
lower regime. However, if the
error message recurs, contact the
authorized service.
Contact the authorized service.
Contact the authorized service.
The connections should be
checked. If the connections
appears as they should be, but the
error message is repeated,
the authorized service.
Contact the authorized service.
Contact the authorized service.
Contact the authorized service.
Contact the authorized service.
Contact the authorized service.
Contact the authorized service.
Contact the authorized service.
08/2022 Rev. 1.1
contact