Installation - Lec U6014W/S User Manual

Installation

Transportation
Caution: 2 people are required to
unpack and handle the appliance, it is
recommended that gloves are worn.
 The appliance should be transported only in
an upright position. Do not tilt the appliance
greater than 45. The packaging as supplied
must be intact during transportation.
 After transporting the appliance, leave it for at
least 4 hours before switching on to allow the
cooling system to settle. Failure to comply
could result in damage to the appliance.
 Do not move the appliance by pulling the door
or handle as it may damage your flooring and
wall coverings etc.
 Ensure the supply cable is not caught under
the appliance during and after moving.
 Carefully remove all packaging materials
including the foam base, dispose of correctly.
Installation
 Make sure that sufficient room is provided
around the appliance to ensure free air
circulation.
 Screw in the two spacers (provided) at the
back of the appliance.
 Do not place the appliance near a heat source
or in direct sunlight.
 Do not put any heavy objects on top of the
appliance. It will damage the appliance.
 Do not install the appliance in moist and wet
place.
 Adjust the feet at front to level the appliance.
It should be installed on a smooth surface to
avoid excessive vibration and noise.
 Each appliance has a climate class (shown on
the rating plate) where it indicates the
temperature range of the appliance operation
in place. The appliance may not work properly
if it is left for a long period at a temperature
outside the specified range.
 Refer to section "Care and Maintenance" to
prepare your appliance for use.
Climate Class
Amb. T. (C)
SN
10 ~ 32C
N
16 ~ 32C
ST
16 ~ 38C
T
16 ~ 43C
Amb. T. (F)
50 ~ 90F
61 ~ 90F
61 ~ 100F
61 ~ 110F
4