Installation Instructions - Lec TF55153W Owner's Manual

Care must be taken while cleaning/carrying the appliance not to touch the
bottom of the condenser metal wires at the back of the appliance, as this
could cause injury to fingers and hands. .
Make sure that the mains cable is not caught under the appliance during
and after moving, as this could damage the cable.

INSTALLATION INSTRUCTIONS

1. Do not place the appliance near cookers,
radiators or in direct sunlight as this will
cause your appliance to work harder. If
installed next to a source of heat or freezer,
maintain the following minimum side
clearances:
From Cookers 2" (50 mm)
From Radiators 12" (300 mm)
From Refrigerators or Larder Fridge 1" (25
mm)
4. Make sure that sufficient room is
provided around the appliance to ensure
free air circulation. Keep the space from
wall to the condenser at least 10cm
5. The fridge/freezer should be located on a
smooth surface. The two front feet can be
adjusted as required. To ensure that, your
appliance is standing upright adjust the two
front feet by turning clockwise or anti-
clockwise, until the product is in firm
contact with the floor. Correct
adjustment of feet avoids excessive
vibration and noise.
6. Refer to cleaning and care section to prepare
your appliance for use.
WARNING!
WARNING!
Do not connect your appliance to the electricity supply until all the packaging
materials have been removed including polystyrene block(s) inserted between
the compressor motor and the cabinet (see diagrams). Do not remove the
plastic drain tray fitted above the compressor motor on models with auto -
defrost fridge.