Table of Contents
Advertisement
GB/IE
Electrical requirements
Before inserting the plug into an electrical
socket make sure that the voltage and the
frequency shown in the rating plate inside the
appliance corresponds to your electricity
supply.
We recommend that this appliance is
connected to the mains supply via a suitably
switched and fused socket which is in a
readily accessible position when the appliance
is installed.
Warning! This appliance must be earthed.
Repairs to electrical equipment should only be
performed by a qualified technician. Incorrect
repairs carried out by an unqualified person
are carry risks that may have critical
consequences for the user of the appliance.
ATTENTION!
This appliance operates with R 600a which is
an environmental friendly but flammable gas.
During the transportation and fixing of the
product, care must be taken not to damage
the cooling system. If the cooling system is
damaged and there is a gas leak from the
system, keep the product away from ignition
sources and ventilate the room for a while.
WARNING - Do not use mechanical devices
or other means to accelerate the defrosting
process, other than those recommended by
the manufacturer.
WARNING - Do not damage the refrigerant
circuit.
WARNING - Do not use electrical appliances
inside the food storage compartments of the
appliance, unless they are of the type
recommended by the manufacturer.
Transportation instructions
1. The appliance should be transported only in
an upright position. The packing as supplied
must be intact during transportation.
2. The appliance should not be operated for at
least 12 hours after installation, to allow the
system to settle.
3. Failure to comply with these instructions
could result in damage to the appliance, for
which the manufacturer will not be held
liable.
4. The appliance must be protected against
rain, moisture and cold.
Important!
• Care must be taken while cleaning/carrying
the appliance not to touch the bottom of the
condenser metal wires at the back of the
appliance, as this could cause injury to fingers
and hands.
• Do not to sit or stand on top of your
appliance as it is not designed for such use.
You could injure yourself or damage the
appliance.
WARNING - Make sure that the mains cable
is not caught under the appliance during and
after moving, as this could damage the cable.
• Do not allow children to play with the
appliance or tamper with the controls.
Installation instructions
1. Do not keep your appliance in a room
where the temperature is likely to fall below
10 degrees C (50 degrees F) at night
and/or especially in winter, as it is designed
to operate in ambient temperatures
between +10 and +32 degrees C (50 and
90 degrees F). At lower temperatures the
appliance may not operate, resulting in a
reduction in the storage life of the food.
2. Do not place the appliance near cookers or
radiators or in direct sunlight, as this will
cause extra strain on the appliance's
functions. If installed next to a source of
heat or freezer, maintain the following
minimum side clearances:
From Cookers 30 mm
From Radiators 300 mm
From Freezers 25 mm
3. Make sure that sufficient room is provided
around the appliance to ensure free air
circulation (Fig 2).
• Open the door of your appliance to ensure
there is enough space for the door to open
properly.(Fig 2).
Fit spacers on the condenser as per Fig 3.
8
Instruction for use
Hide quick links:
Advertisement
Table of Contents
