Safety Information (continued)
Before each use of this gas appliance, open the LP (liquid propane) tank drawer and inspect the LP hose. If there is
evidence of excessive abrasion or wear, or the hose is cut, it must be replaced prior to the gas appliance being put
into operation. Use only the replacement hose assembly specified in this manual. Inspect the burner before each use
of the appliance. The burner must be replaced prior to the appliance being put into operation if it is evident that the
burner is damaged. Use only the burner listed in these instructions.
Keep the fuel supply hose away from any heated surfaces.
Very hot while in operation! Never lean over the appliance while it is in use.
In order to protect the burner system, when the fire is not in use and on rainy days, the cover should be used.
Do not use cover immediately after use, wait until the appliance has cooled down.
Do not sit or stand on this table.
Retain these assembly instructions for future reference.
ABOUT PROPANE (LP) GAS
A self contained LP gas cylinder for use with this appliance must have a capacity of 20 lb. and must be equipped with a Type 1 connector
and an OPD (overfill protection device). See Figure 1.
The LP gas supply cylinder to be used must be constructed and marked in accordance with the specification for LP gas cylinders of the
U.S. Department of Transportation (DOT) or the National Standard of Canada, CAN/CSA-B339, Cylinder, Sphere and Tubes for the
Transportation of Dangerous Goods.
The cylinder supply system must be arranged for vapor withdrawal.
The cylinder used must include a collar to protect the cylinder valve.
This appliance shall be used only outdoors in a well-ventilated space and shall not be used in a building,
garage or any other enclosed space.
When this appliance is not in use, the gas must be turned off at the supply cylinder.
Storage of this appliance indoors is permissible only if the cylinder is disconnected and removed from the appliance.
Cylinders must be stored outdoors in a well-ventilated area out of the reach of children. Disconnected cylinders must have threaded valve
plugs tightly installed and must not be stored in a building, garage or any other enclosed areas. CSA (Canadian Standards Association)
certified to ANSI Z21.97·CSA 2.41-2017 "Outdoor Decorative Gas Appliances".
Figure 1
4
Need help?
Do you have a question about the 2364FP and is the answer not in the manual?