Table of Contents
Advertisement
Chapter 4 Look over INS (internal statement number) of load cell
Please plug calibration plug into 15 pins RS232 at the back of indicator for load cell INS
information. The ISN provides technical parameters for manual Corner adjustment and
information for us to judge it is malfunction or not. Please refer to the below chart for
detailed information.( * is original value, load cell number starts 01, if 4 load cells in total
they are 01,02,03,04)
Step
Press
[check ]
1. Select the
number
of
Press [0][2]
load cell
Press
[check ]
2.
ISN
Press
display
[check ]
Notice please plug off the calibration plug when operation finishes
When mistake happen which be caused by hot plug in or off, please press key "check"or
"power off" for a new set up
www.kelichina.com
Operation
Display
[no-01]
[no-02]
[ 2350]
Remark
Plug in calibration plug under weighing
state
Default: check cell 01 ISN
command: check cell 02 ISN
No. 02 load cell 02 ISN is 02350
When finish, it returns to weighing state.
Page 15 of 38
Advertisement
Table of Contents
