Fantec mobiRAID X2U31 Manual

MANUAL
FANTEC mobiRAID X2U31
2x 2.5" SDD & HDD Enclosure
JBOD / RAID0 / RAID1
3. LED displays
Display
Blue glowing
Installed
Flashing blue Ac-
cess
Off Standby / Not
installed
Red flashing De-
fective
4. Interfaces
Nr.
1
2
3
4
Status
Installed
Access
Standby / Not
installed
Defect
Interface Description
USB-C Data transfer to PC
Reset To change the RAID
button mode
RAID Switch For setting
the RAID mode
DC IN Additional power
supply if the power
supply at the USB
3.1 slot is not suf-
ficient
-2-
1. Introduction
Thank you for purchasing your new FANTEC mobiRAID
X2U31 2X SSD & HDD RAID enclosure. This device supports
very flexible RAID (Redundant Array of Independent Disks)
configuration. Due to the USB 3.1 (USB-C) interface (USB 3.0
compatible), data transfer rates up to 10.0 Gbit/s are possible
and as a special advantage, the operation without additional
power supply has to be mentioned. These features guarantee
exceptionally flexible application options for your RAID enclosure.
Before you start installing
device, please read
2. Scope of delivery FANTEC mobiRAID X2U31
Your package contains the following components
5. Hard disk installation
a) Pull the inner frame out of the aluminum case.
b) First install the hard disk in the bay of disk 1 and only then
install another hard disk in the bay of disk 2. At this point we
also recommend marking the hard disks accordingly with the
supplied stickers disk 1 and disk 2. If there is damage to one of
the hard disks later, the hard disks can be identified more easily.
Disk 1
and setting up
this manual carefully.
FANTEC mobiRAID X2U31
incl. stand
Instruction manual
Accessories (mounting
screws, stickers)
USB 3.1 (USB-C) cable for
data transfer
USB cable for additional
power supply
-1-
-3-
the