Fantec US330 Manual

Fantec US330 Manual

4bay us33.0

Advertisement

Diagram
STEP
FUNCTION BUTTONS
INTERFACE
SYNC
FAN
Power
Press to open
FORCED CONVECTION PROCESS

FRONT PANEL

REAR PANEL

DESCRIPTION
eSATA port
USB 3.0 port
Smart fan
DESCRIPTION
Blue
Orange
eSATA
USB
eSATA
USB
Fan speed
Fan speed
Fan speed
Synchronization
Blue
Orange
Off
Power
Smart Fan automatic mode
Smart Fan manual mode
Interface switch
Synchronization mode switch
Smart fan Switch
Button 17 and 18 need to be pressed for 3 seconds to switch the device's mode.
This design will prevent accidental execution of these functions.
SIDE PANEL right
DESCRIPTION
DC Jack
DC Power
Smart fan easy to install and dismantle
AC input 100V ~240V
DC output 12V / 5A
power on
standby
on/off line
on/off line
in use / access
in use / access
level 1
level 2
level 3
3 modes
When the PC is off, the device goes off in 15 seconds.
When the PC is off, the device goes to sleeping mode.
Synchronization is off.
Prees 3 seconds to power off the device.
HDD1 / HDD2 / HDD3 / HDD4 active
auto, manual and fan speed from level 1 to level 3
HDD HANDLE
FRONT COVER
METAL FRAME
SMART FAN
USB 3.0
eSATA

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the US330 and is the answer not in the manual?

Questions and answers

Summary of Contents for Fantec US330

  • Page 1: Front Panel

    Diagram STEP FUNCTION BUTTONS INTERFACE SYNC Power Press to open SMART FAN FORCED CONVECTION PROCESS Smart fan easy to install and dismantle USB 3.0 eSATA AC input 100V ~240V DC output 12V / 5A DESCRIPTION FRONT PANEL Blue power on Orange standby eSATA...
  • Page 2 Adjust the metal frame that was removed back to the chassis and close the cover (based on how it was opened in Step 2). Connect the FANTEC QB-35US3 to the power adapter, plug in USB or eSATA cable in the rear panel and power on the device.
  • Page 3 Windows 2000 / XP Windows Vista/7 (32/64bit) STEP STEP Diskmgmt.msc Diskmgmt.msc Initialize Disk if it is a new one. Create a new partition and format the hard drive: Next finish Format finished t finished Format finished Macintosh 10.X O.S STEP In “Disk Utility”...
  • Page 4 Note STEP STEP If the FANTEC QB-35US3 (4 HDDs installed) is connected to the USB port of your PC must support power-off function so that the PC with eSATA cable and the PC does not recognize these device would go to sleeping mode. Setting up motherboard's 4 SATA HDDs, please check if the eSATA controller supports Port Multiplier or update the eSATA driver version.

This manual is also suitable for:

Qb-35us3

Table of Contents