Troubleshooting - Makita DUP361 Instruction Manual

4. Remove two
the switch
the hex wrench.
Remove the trigger
separating the tongue
trigger guard from the groove of the housing. ►
Fig.30: 1. Bolts 2. Trigger guard
5. Remove the E-ring on the link arm with a slotted
screwdriver or alike.
►
Fig.31: 1. E-ring 2. Link arm
NOTICE:
The E-ring
expendable
not re-use
when reassembling.
Carefully remove the pin. ► Fig.32:
6.
7. Remove two
the side
housing. ► Fig.33:
8. Carefully remove the upper and lower shears from
the housing. ►
Fig.34
9. To separate the
and the
first loosen
fixing bolt.
Then remove the lock plate.
►
Fig.35: 1.
bolt 2. Lock plate
NOTE: When replacing
for hard
ones for
or vise
the plate
as well.
10. Loosen and
blades tightening nut.
►
Fig.36: 1. Blade tightening nut 2. Blade
tightening bolt
NOTE: When replacing
for hard
ones for
or vise
the blade
as well.
To install the
perform the procedures above
reverse. Make sure
bolts are securely
After installing the
adjust the blade
"Adjustment
to
clearance".)
To install the
perform the procedures above
bolts near
trigger with
guard by
on the
is
part. Do
the E-ring
1. Pin
bolts from
of the
1. Bolts
upper blade
lower blade,
the plate
Plate fixing
the blades
branch with
thin branch,
versa, replace
fixing bolt
remove the
the blades
branch with
thin branch,
versa, replace
tightening bolt
shear blades,
in
all the
tightened.
blade, always
clearance. (Refer
for blade
shear blades,
in
22 ENGLISH
reverse. When installing
blades, pay attention to the following points:
•
Apply machine oil
on to
tightening bolt
the blades.
•
If you can
the plate
properly, first,
O-ring and
fixing bolt
And then overturn the lock plate,
return the
the plate
•
When installing the trigger guard, align the tongue
of the trigger guard with the groove of the housing.
►
Fig.37
•
Make sure all
are securely
•
After installing the
adjust blade
"Adjustment
to
clearance".)
blade
•
After installing the
adjust cutting
"Cutting
to
adjustment".)
Trouble shooting
Before making a
repairs, check for
yourself. If any
is found, control
according to the description of this manual. If the
remedy mentioned below
the problem, ask
service center for repair. Never tamper or dismount any
part contrary to the description.
State of Probable cause
abnormality (malfunction)
The The
she
ar ery
blad
e
I/O switch is "Off"
doe
position.
s not move even
after pulling the
The shears are
switch trigger.
locked.
Connection cord
is loose.
the shear
or grease
the blade
and between
not place
fixing bolt
remove the
the plate
from the lock plate.
and
O-ring and
fixing bolt.
the bolts
tightened.
blade, always
clearance. (Refer
for
blade, always
depth. (Refer
depth
request for
trouble by
abnormality
your tool
cannot solve
your local authorized
Remedy
Charge the
batt battery.
is
low.
Press the I/O switch to
"I" position.
Unlock the
shears
by
performin
g the steps in "Switch
action".
Check the connecting
points of
the
switch
box
and
shears of connection
cord.