Makita DUP361 Instruction Manual page 16

the lamps
box lights
Overload protection
When the tool is operated in a manner that causes it to
draw an
the tool
without any indication. In this situation, turn the tool off
and stop the application that caused the tool to become
overloaded.
tool on
Overheat protection
When the tool is overheated, the tool stops
automatically,
lamp on
blinks. In
the tool
turning the
Overdischarge protection
When the
low, the
automatically.
lamp on
lights up
the product
even when
operated, remove
the battery
the batteries.
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
►
Fig.3: 1. Indicator lamps 2.
Check button
Press the
the battery
the remaining battery
indicator lamps
on the
up.
abnormally high
automatically
Then turn
to restart.
and the
the switch
this situation,
cool down
tool on again.
battery capacity
tool stops
And the
the switch
or blinks.
does not
the switches
the batteries
holder and
check button
cartridge to
capacity.
light up for a few seconds.
switch
Lighted
current,
stops
the
green
box
let
before
NOTE: Depending on the conditions of use and the
ambient
becomes
red
box
If
Switch action
operate
are
from
charge
Auto locked-mode and shut-off
mode shift
CAUTION:
the shears, always check to see that the switch
trigger actuates properly and returns to the "OFF"
on
position when released.
indicate
CAUTION:
The
always make sure that the I/O switch is on the "O"
side.
CAUTION:
"I" (on) position while pulling the switch trigger.
The
To turn on the tool, perform as follows:
1.
(Refer to "Installing the connection cord".)
2.
The green pilot lamp lights up.
16 ENGLISH
Indicator lamps
Off Blinking
temperature,
indication may
from the actual capacity.
Before connecting the battery to
When not operating the tool,
Do not press the I/O switch to the
blade closes
it may
personal injury.
Connect the
connection cord,
Hold the
and press
switch to
Remaining
capacity
75 % to 100%
50 % to 75%
25 % to 50%
0 % to 25%
Charge the
battery.
The
may have
ba
malfunctioned.
the
differ slightly
slightly and
cause
switch box,
and shears.
shears firmly,
the I/O
the "I" (on) position.