Connect Camera; Camera Positioning, Field-Of-View, Set-Up And Focus - Iqinvision IQM30NE-B5 Installation And Operating Instructions Manual

9. Connect Camera

1. Route and connect the Power-over-Ethernet cable to
the Ethernet connector port on in the camera as shown
in Figure 9.1.
2. Route and connect the optional (not supplied) audio
cable when using an external microphone and
powered loudspeaker (not supplied) to the
Alliance-mx dome camera as shown in Figure 9.2.
The external microphone and powered loudspeaker
(not supplied) will connect to 3.5mm audio
connectors.
10. Camera Positioning, Field-of-View,
Set-up and Focus
1. Set the field-of-view using the 3-axis gimbal.
Determine camera pan direction by gripping the
camera assembly, and carefully pivot the camera to
the viewing direction.
2. Adjust the tilt of the camera by loosening the tilt angle
lock screws as shown in Figure 10.1, and tilt the camera
to the viewing direction. When finished, tighten the tilt
locking screws.
3. Adjust the field-of-view and focus rings to achieve
the desired focus as shown in Figure 10.2.
NOTE: The lens on the Alliance-mx dome camera
is fixed iris and therefore no iris adjustment
is needed.
When finished, tighten the thumbscrews on the lens.
Optional Audio
Focus Control
Zoom Control
8
Figure 9.1
Audio cable can Only
In/Out Cable Pass Through the
Assembly Conduit Entry
Figure 9.2
Figure 10.1
Figure 10.2