Table of Contents
Advertisement
WARNING: Use supply wires suitable for 90°C.
AVERTISSEMENT: Employer des fils d'alimentation adeqauts pour 90°C.
WARNING: Disconnect power when servicing.
AVERTISSEMENT: Couper l'alimentation lors de l'entretien.
CAUTION: Use flexible conduit only. Not for use with rigid conduit.
AVERTISSEMENT: N'utiliser que du conduit flexible ; n'est pas fait pour du conduit rigide.
WARNING: SERVICING OF DOUBLE-INSULATED APPLIANCES. A double-insulated appliance
is marked with one or more of the following:
The words "DOUBLE INSULATION" or "DOUBLE INSULATED" or the double insulation
symbol (square within a square). In a double-insulated appliance, two systems of
insulation are provided instead of grounding. No grounding means is provided on a
double-insulated appliance, nor should a means for grounding be added.
Servicing a double-insulated appliance requires extreme care and knowledge of the
system, and should be done by qualified service personnel. Replacement parts for
a double-insulated appliance must be identical to the parts they replace.
5. Wiring the circulator: Disconnect the
AC power supply. Remove the terminal box
cover. Attach a wiring connector into the
knockout hole. Use a flexible conduit only.
Connect Line/Hot power to the black
lead, neutral to the white lead. See wiring
diagram to the right. Replace the terminal
box cover.
Note: If pigtail leads provided are not used, be sure
to trim field wire to a strip length of .25" (+/- .025")
to prevent exposed wire causing a short at the
terminal plug. Connect line and neutral to green
terminal plug as shown in the Wiring Diagram.
Depress the spring tab with a small screwdriver to
insert wire into the plug. Release tabs to complete
connection. The 007e is a double insulated circula-
tor. No grounding wire is necessary.
6. Start the circulator: When purging the system, it is recommended to run the circulator long
enough to remove all remaining air from the bearing chamber. This is especially important when
installing the circulator in the off-season. An orange LED will illuminate when the 007e is
powered on.
7. Green Mode: Responsive technology actively monitors system conditions and automatically
adjusts to optimize power consumption. In this mode the LED changes to green. Consult with the
factory for directions to access Green Mode.
CAUTION: Never run the circulator dry or permanent damage may result.
ATTENTION: Ne laissez jamais le circulateur tourner à sec, des dommages
permanents peuvent en résulter.
CAUTION:
Do not attempt to remove LED panel from circulator. Serious damage to circulator electronics may result.
ATTENTION:
N'essayez pas de retirer le panneau de LED du circulateur. Des dommages sérieux à l'électronique du
circulateur peuvent en résulter.
-6-
Advertisement
Table of Contents
