Error Codes - GE Profile DPVH890EJ Technical Service Manual

Error Codes

Error Component,
Code System, or Test
E1 Interface EEPROM
E101 Power EEPROM
E2 Inlet Short
E4 Inlet Open
E3 Outlet Short
E5 Outlet Open
E61 Check Electrical
Connection
E81 Power Model
E10 Blower Motor
E11 Blocked Airfl ow
E12 Drum Motor
E16 LIN Comm Fail
E17 VFD Communication
Error
E18 Stuck Button
Description and Corrective Action
Reading or writing improperly. Replace UI board.
Reading or writing improperly. Replace power board.
Inlet thermistor shorted; check and replace if necessary.
Inlet thermistor open; check and replace if necessary.
Outlet thermistor shorted; check and replace if necessary.
Outlet thermistor open; check and replace if necessary.
Input voltage too high; please check power connections.
No model select connector detected; check model selector on power
board.
Blower motor is not rotating properly. Please check.
Check ventilation system.
Motor is not rotating properly or centrifugal switch is bad. Please check.
There is a problem with the communication between the machine
control and the UI control.
There is a problem with the serial communication interface between
the UI and the VFD.
Stuck keys. Please check.
– 43 –