Parts & Features - LG PrintProof LSDL6336 Series Owner's Manual

us_main.book.book Page 73 Thursday, January 27, 2022 1:33 PM
Parts & Features
Problem
Range is not level. Poor installation.
• Place oven rack in center of oven. Place a level on the oven rack. Adjust leveling legs at
• Be sure floor is level and strong and stable enough to adequately support range.
• If floor is sagging or sloping, contact a carpenter to correct the situation.
Kitchen cabinet alignment may make range appear unlevel.
• Be sure cabinets are square and have sufficient room for range clearance.
Cannot move Cabinets not square or are built in too tightly.
appliance easily.
• Contact builder or installer to make appliance accessible.
Appliance must be
accessible for Carpet interferes with range.
service.
• Provide sufficient space so range can be lifted over carpet.
Anti-tip device engaged.
• Uninstall the anti-tip device to move the range. Reengage the anti-tip device after pulling
Oven control beeps Electronic control has detected a fault condition.
and displays any F
• Turn off the oven function you are using to clear the display and stop beeping. Reprogram
code error.
Displayed colon in This means that the product has just been plugged in, or that it has experienced a
the clock is flashing power interruption.
• This is normal. Reset the clock or press any button to stop the flashing.
CLEAN and door The Self Clean cycle has been selected, but the door is not closed.
flash in the display
• Close the oven door.
(On some models)
Loc is on in the The oven is locked because of the Control Lock / Lockout feature.
display when you
• Deactivate the Control Lock / Lockout feature.
want to cook (On
some models)
The oven door is locked because the temperature inside the oven has not dropped
below the locking temperature.
• Allow the oven to cool.
Oven light does not It is time to replace the lamp/bulb or it is loose.
work.
• Replace or tighten lamp/bulb. See "Changing the Oven Light" section in this Owner's
Convection fan Convection fan stops during a convection bake cycle. It is done to allow for more even
stops. (During heating during the cycle.
Conv.Bake mode)
• This is not a failure of the range and should be considered normal operation.
Oven will not Self The oven temperature is too high to set a Self Clean operation.
Clean. (On some
• Allow the range to cool and reset the controls.
models)
Oven controls improperly set.
• See the Self Clean section.
A Self Clean cycle cannot be started if the oven Control Lock / Lockout feature is active.
• See the "Control Lock / Lockout" in "Changing Oven Settings" section.
base of range until the oven rack is level.
the range out for cleaning, service, or any other reason.
oven. If fault recurs, record fault number and contact a service agent.
Manual.
TROUBLESHOOTING
Possible Cause & Solution
73