Other Specifications; Installation; Dispenser Mounting; System Connection - Panduit PAT1M Operation Manual

OTHER SPECIFICATIONS

Peak Sound Level during cycle
PAT1M/PAT1.5M Tool Vibration
* As measured in accordance with ISO 11202: 1995 (E).
** As measured in accordance with ISO 5349.

INSTALLATION

DISPENSER MOUNTING

After unpacking the components, mount the carrier strip scrap bin (See Figure 1) on the left side of the dispenser by
positioning the larger holes in the bin over the cap screws on the dispenser, and sliding the bin down. Attach the tool
holder bracket (See Figure 2 on Page 7) to the front of the dispenser by positioning the larger holes in the tool holder
PAT1M/PAT1.5M: PA22222A01_03
Downloaded from Elcodis.com electronic components distributor
PAT1M / PAT1.5M OPERATION MANUAL
ITEM
PDM DISPENSER
COMPONENT LIST
1. XMR Reel Mount Assembly
2. Male Air Inlet
3. Power Switch/Fuse Holder
4. Power Cord Receptacle
5. Buzzer/Volume Adjustment
6. Carrier Strip Exit Chute
7. Carrier Strip Scrap Bin
DESCRIPTION
76 dBA (average)*
Less than 2.5 m/s
bracket over the cap screws on the
dispenser, and sliding the bracket
down into position. Refer to Page 26
for alternate mounting to walls, carts
or bench tops. Always position the
dispenser in the work area so there
are no severe bends or twists in the
PHM Feeder Hose.

SYSTEM CONNECTION

1. Connect
disconnect end of the air hose
and filter/regulator assembly to
the male air inlet on the back of
the dispenser (See Figure 1).
2. Connect the filter/regulator to the
main (NON-LUBRICATED) air
supply and set the filter regulator
at
performance (Refer to the Air
Supply section on Page 5).
3. Verify installation by reviewing the
Installation
below.
Fig. 1
Page: 6 of 36
2
**
the female quick
65 PSIG for optimum
section
Checklist
Dec., 2007