Table of Contents
Advertisement
SECTION 2: INSTALLATION
Content
1
GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-1
2
OFFICE REQUIREMENTS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-1
2.1
2.2
2.3
2.4
3
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-3
3.1
3.2
3.3
3.4
4
POWER APPLICATION AND SYSTEM CHECKOUT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-11
_________________________________________________________________________________________________________
1 GENERAL
This section provides complete instructions for installing the DSX-3 (DSX-4U-24) Rear Cross-
Connect System. It is recommended that the entire section be read and understood before
beginning installation.
2 OFFICE REQUIREMENTS
2.1
Space and Floor Loading
The cross-connect system consists of up to 240 circuit modules mounted in a standard 2.13 m ×
48.26 cm (7-foot × 19-inch) unequal flange equipment bay. Maximum width of the bay is 55.72 cm
(21.94 inches), and maximum depth is 30.47 cm (12 inches). A fully configured unwired/uncabled
cross-connect system bay weighs approximately 163 kg (360 pounds).
2.2
Environment
2.2.1
Shipping and Storage
The cross-connect system must be shipped and stored in ambient temperatures and humidities
which do not exceed the following:
• Temperature: -55° to +85° C (-67° to +185° F).
• Relative Humidity: 0% to 95% without condensation.
Space and Floor Loading . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-1
Environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-1
Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-2
Cable Types and Lengths . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-2
Bay Installation/Expansion . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-3
Circuit Module Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-4
Installation of Office/Equipment Cabling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-5
Cross-Connect Jumpers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-9
ADCP-80-353 • Issue 2 • August 2002 • Section 2: Installation
© 2002, ADC Telecommunications, Inc.
Page
Page 2-1
Advertisement
Table of Contents
