Functional Description - Makita AF353 Instruction Manual

Lubrication
► Fig.4
To insure maximum performance, install an air set (oiler,
regulator, air filter) as close as possible to the tool.
Adjust the oiler so that one drop of oil will be provided
for every 50 nails.
When an air set is not used, oil the tool with pneumatic
tool oil by placing 2 (two) or 3 (three) drops into the air
fitting. This should be done before and after use.
For proper lubrication, the tool must be fired a couple of
times after pneumatic tool oil is introduced.
► Fig.5: 1. Pneumatic tool oil
FUNCTIONAL
DESCRIPTION
CAUTION:
Before adjusting or checking func-
tion on the tool, always return the trigger and lock
lever and disconnect the hose.
Trigger and lock lever
WARNING:
Make sure that your fingers are
not placed on the trigger and lock lever when con-
necting the hose. Otherwise the tool may misfire
and result in personal injury.
The tool is equipped with a lock lever to prevent the
trigger from pulling accidentally.
To drive the pin nails, first pull the lock lever, and then
pull the trigger.
► Fig.6: 1. Lock lever
► Fig.7: 1. Trigger
Checking safety system
WARNING:
Make sure all safety systems are
in working order before operation. Failure to do so
may cause personal injuries.
CAUTION:
Make sure that the tool is not
loaded with pin nails.
► Fig.8: 1. Trigger 2. Lock lever
Before pin nailing operation, check the safety system
as follows:
1. Pull the sliding door of the magazine toward your-
self to release the anti dry fire mechanism.
2.
Unload the tool.
3. Make sure that you cannot pull the trigger when
the lock lever is not pulled.
4. Make sure that you can pull the trigger after you
pull the lock lever.
If the tool fails the check above, stop using the tool and
ask authorized service center for repairing.
Hook
CAUTION:
Make sure that your fingers are not
placed on the trigger or lock lever and disconnect
the hose from the tool before using the hook.
CAUTION:
Never hook the tool at high loca-
tion or on potentially unstable surface.
CAUTION:
Do not hang the hook from the
waist belt. If the nailer accidentally drops, it may
result in misfiring and personal injuries.
► Fig.9: 1. Hook
The hook is convenient for hanging the tool temporarily.
Hex wrench storage
When not in use, store the hex wrench as shown to
keep it from being lost.
► Fig.10: 1. Hex wrench
Air duster
CAUTION:
Do not aim the ejection port of the
air duster to someone. Also, keep your hands and
foot away from the ejection port. If the air duster
button is accidentally pushed, it may cause a per-
sonal injury.
CAUTION:
Always check your surroundings
before using the air duster. Blown dust or objects
may hit someone.
CAUTION:
Do not connect or disconnect the
air hose while pushing the air duster button.
The air supplied to the tool can also be used as an air
duster. You can clean the work area by pressing the
button on the grip end.
► Fig.11: 1. Button
NOTICE:
After using the air duster, the driving force
of the tool will temporarily decline. Wait until the air
pressure recovers in this case.
NOTICE:
Perform a test blow if you use the air
duster immediately after the oil was applied. The oil
may be sprayed with the air.
10 ENGLISH