Interquartz 9310 Manual

General

This INTERQUARTZ telephone is intended for use on 2 wire analogue PSTN and PABX circuits within
Europe.

Declaration of Conformity

Interquartz (UK) Limited declares under its sole responsibility that this product
Is in conformity with the following relevant harmonized standards
Electromagnetic Compatibility
Telecoms
Following the provisions of Council Directive on radio equipment and telecommunications terminal equipment
Notes
1. The REN number of this telephone is 1.
2. The European code for emergency services is 112. You can still use 999 in the UK. An access code may
be required, if the phone is connected to a PABX.

Installation

1. Insert the line cord into the line socket (refer to Figure 2).
2. Insert the handset cord into the handset socket.
3. Set the ringer volume control as desired.
4. Position the telephone where you want to wall mount. Drill two holes and fix roundheaded screws,
leaving them slightly proud of the surface. Position the telephone over the screws and slide downwards
into place.
5. Before you attempt to change the ER/TBR Recall switch, you should disconnect the phone from the
network. Contact your PABX Manager or Network Supplier if you need to adjust the Recall switch
(ER/TBR) and Voice Message (S1/S2/N) switch.
IQ10 Basic Phone 9310
Model: IQ10 Basic Phone
EN55022: 1998 & EN55024: 1998
EN301437:1999 & TBR38:1998
May 2003