Metra Electronics ABTI-GM4 Installation Manual

ABTI-GM4
5) Connect the 14 pin cap on the ABTI-GM4 cable to the 14 pin
plug connected to the vehicle (the connector that was removed
from the back of the radio).
FROM CAR
FROM CAR
FROM CAR
FROM CAR
White
8 pin
plug
6) Connect the 16 pin cap on the ABTI-GM4 cable to the 16 pin
IHF-1000 keypad
plug connected to the vehicle (the connector that was removed
from the back of the radio).
FROM CAR
FROM CAR
FROM CAR
FROM CAR
White
8 pin
plug
IHF-1000 keypad
7) Connect the white 10-pin plug on the ABTI-GM4 cable to the
ABTI-GM4 module.
FROM CAR
FROM CAR
FROM CAR
FROM CAR
White
8 pin
plug
IHF-1000 keypad
8) Connect the white 8 pin plug on the IHF-1000 cable to the
ABTI-GM4 power cable, and connect the other end of the power
cable to the ABTI-GM4 module.
4
9) Install the IHF-1000 keypad on the dashboard of the vehicle,
and route the wire to the IHF-1000 harness. Attach the keypad
connector to the harness.
ABTI-GM4
FROM CAR
FROM CAR
FROM CAR
FROM CAR
10) Install the IHF-1000 microphone in an appropriate location
(see IHF-1000 instructions), route the wire to the IHF-1000 har-
ness, and attach the microphone connector to the harness.
ABTI-GM4
11) Secure all components, and reinstall the radio.
12) Reconnect the vehicle battery.
OPERATION
Refer to the IHF-1000 manual for operation. All audio signals from
the IHF-1000 will be played through the car stereo. Adjust the vol-
ume using the radio's volume knob to a comfortable level. Audio
from FM, CD, Satellite etc. will be automatically paused or muted
while calls are in process. Any OnStar operations will preempt the
ABTI-GM4
operation of the IHF-1000. Keep in mind that if OnStar operations
start while you are on a call, the call will continue and the caller will
be able to hear you – watch what you say!
The vehicle's radio does not need to be on for IHF-1000 operations,
but the vehicle's ignition must be on or in accessory mode.
REV. 08/24/07
1-800-221-0932
©Copyright 2007 Metra Electronics Corporation
ABTI-GM4
ABTI-GM4
White
8 pin
plug
IHF-1000 keypad
INSTABTI-GM4
www.metraonline.com
ABTI-GM4
ABTI-GM4
GENERAL MOTORS
LAN
BLUETOOTH INTERFACE
MANUAL
INSTALLATION
The ABTI-GM4 is designed to allow full integration of Motorola's
IHF-1000 Bluetooth Hands free kit (Sold separately) with GMLAN
vehicles listed above. The kit will allow users to listen to phone
calls through their car stereo. The currently playing radio source
will be automatically muted, and the phone volume may be con-
trolled by the radio. OnStar operation is unaffected.
* READ IMPORTANT WARNING ON PAGE 1
BEFORE ATTEMPTING ANY INSTALLATION
A A P P P P L L I I C C A A T T I I O O N N S S I I N N C C L L U U D D E E : :
CHEVROLET
Cobalt 2007
HHR 2006-07
PONTIAC
G5 2007
Solstice 2006-07
SATURN
Aura 2006-07
Sky 2006-07
1-800-221-0932 www.metraonline.com
©Copyright 2007 Metra Electronics Corporation