Metra Electronics ABTI-GM2 Installation Manual

ABTI-GM2
5) Connect the 24 pin cap on the ABTI-GM2 cable to the 24 pin
plug connected to the vehicle (the connector that was removed
from the back of the radio).
FROM CAR
FROM CAR
FROM CAR
FROM CAR
White
8 pin
plug
6) Connect the 12 pin cap on the ABTI-GM2 cable to the 12 pin IHF-1000 keypad
plug connected to the vehicle (the connector that was removed
from the back of the radio).
FROM CAR
FROM CAR
FROM CAR
R
FROM CAR
7) Connect the white 10-pin plug on the ABTI-GM2 cable to the
ROM CAR
ABTI-GM2 module.
IHF-1000 keypad
M CAR
FROM CAR
White
8 pin
plug
IHF-1000 keypad
8) Connect the white 8 pin plug on the IHF-1000 cable to the
ABTI-GM2 power cable, and connect the other end of the power
cable to the ABTI-GM2 module.
4
9) Install the IHF-1000 keypad on the dashboard of the vehicle,
and route the wire to the IHF-1000 harness. Attach the keypad
connector to the harness.
ABTI-GM2
10) Install the IHF-1000 microphone in an appropriate location
(see IHF-1000 instructions), route the wire to the IHF-1000 har-
ness, and attach the microphone connector to the harness.
ABTI-GM2
11) Secure all components, and reinstall the radio.
12) Reconnect the vehicle battery.
OPERATION
White Refer to the IHF-1000 manual for operation. All audio signals from
8 pin
the IHF-1000 will be played through the car stereo. Adjust the vol-
plug
ABTI-GM2 ume using the radio's volume knob to a comfortable level. Audio
from FM, CD, Satellite etc. will be automatically paused or muted
while calls are in process. Any OnStar operations will preempt the
operation of the IHF-1000. Keep in mind that if OnStar operations
start while you are on a call, the call will continue and the caller will
be able to hear you – watch what you say!
The vehicle's radio does not need to be on for IHF-1000 operations,
but the vehicle's ignition must be on or in accessory mode.
REV. 08/14/07
1-800-221-0932
©Copyright 2007 Metra Electronics Corporation
ABTI-GM2
FROM CAR
FROM CAR
ABTI-GM2
FROM CAR
FROM CAR
White
8 pin
plug
IHF-1000 keypad
INSTABTI-GM2
www.metraonline.com
ABTI-GM2
ABTI-GM2
GENERAL MOTORS
LAN
BLUETOOTH INTERFACE
MANUAL
INSTALLATION
The ABTI-GM2 is designed to allow full integration of Motorola's
IHF-1000 Bluetooth Hands free kit (Sold Separately) with the
GMLAN vehicles listed below. The kit will allow users to listen to
phone calls through their car stereo. The currently playing radio
source will be automatically muted, and the phone volume may
be controlled by the radio. OnStar operation is unaffected.
* READ IMPORTANT WARNING ON PAGE 1
BEFORE ATTEMPTING ANY INSTALLATION
A A P P P P L L I I C C A A T T I I O O N N S S I I N N C C L L U U D D E E : :
CHEVROLET
Cobalt 2005-06
Equinox 2005-06
Malibu/Malibu Maxx 2004-07
PONTIAC
G6 2005-07
Torrent 2006
1-800-221-0932 www.metraonline.com
©Copyright 2007 Metra Electronics Corporation