Table of Contents
Advertisement
Problem
"Set clock" appears in the status
bar. The time displayed is not the
current time. "Select language"
appears in the settings area on the
right.
The oven does not heat up.
"Demo" is displayed in the status
bar.
"Automatic switch-off" appears in
the status bar.
The microwave does not switch
on.
The appliance does not heat up to
the temperature which has been
set.
Microwave operation has been
cancelled for no apparent reason.
With microwave operation, the
food takes longer to heat up than
before.
Error messages with E
If an error message with E is shown in the display, press the
button. Then reset the clock. This cancels the error message. If
the error is shown again, call the after-sales service. With error
message E106, you can still operate the microwave.
If error message E011 is displayed, a button may have become
stuck. Press each button individually and check that they are all
clean. If the error message remains, please contact the after-
sales service.
Replacing the oven light bulb
It is possible to replace the oven light. Heat-resistant 12 V,
20 W halogen bulbs can be obtained from After-sales Service
or a specialist retailer.
:
Risk of electric shock!
Never replace the oven light when the appliance is switched on.
Pull out the mains plug or switch off the appliance at the circuit
breaker in the fuse box.
Note: Always remove the new halogen bulb from the packaging
using a dry cloth. This increases the service life of the bulb.
Method
Switch off the circuit breaker in the fuse box.
1.
Place a tea towel in the cold oven to prevent damage.
2.
Remove the glass cover. To do so, prise open the glass
3.
cover at the bottom by hand.
Should you experience difficulties removing the glass cover,
use a spoon to help. (Fig. A)
Possible cause
Power cut
The oven is in demo mode
Automatic switch-off has been activated. The
oven switches off.
Door not fully closed.
The microwave was not started.
The
button was not pressed.
†
The microwave has a fault.
The microwave power setting is too low.
A larger amount than usual has been placed in
the appliance.
The food was colder than usual.
0
Remedy/information
Turn the rotary selector to set the correct time
then press the
remains unchanged following a power cut.
Switch off the circuit breaker in the fuse box
and then switch back on after approx.
20 seconds. Within the next 2 minutes, press
and hold the
"Demo" disappears from the status bar.
Press any button. The text disappears. You
can make settings again.
Check whether food remains or foreign mate-
rial is trapped in the door. Make sure that the
sealing surfaces are clean. Check whether the
door seal is twisted.
Press the
Press the
If this fault occurs repeatedly, please call the
after-sales service. Oven operation without
microwave is possible.
Select a higher power setting.
Double the amount = almost double the time
Stir or turn the food during cooking
Remove the bulb and replace with a bulb of the same type.
4.
(Fig. B)
Refit the glass cover. (Fig. C)
5.
Remove the tea towel. Switch the circuit breaker in the fuse
6.
box back on or plug in the mains plug.
0
button. The language set
button for four seconds until
@
†
button.
button.
†
21
Advertisement
Table of Contents
