Clarion VRX785BT Owner's Manual & Installation Manual page 22

Opening the Liquid Crystal Panel and Adjusting the Angle
Note:
• If the liquid crystal panel stops in the middle of its
operation, press the [OPEN] button to house the
panel and press the button again to raise it. The
unit will enter the same display mode as the
display was in when last turned off.
70˚
Panel calibration function
The liquid crystal panel's maximum angle of
inclination can be adjusted to match the
installation configuration within the vehicle.
• Perform this with the panel in its housed
position.
1. Keep pressing the [OPEN] button more than 5
seconds.
The electronic beep will be heard.
After the beep sounds twice, the panel will
come out and stand up to the maximum angle.
After completion of the calibration, the panel
will be housed into the unit automatically.
• If the panel does not strike the instrument
panel or other parts of the car during
calibration, the maximum inclination will be
110°.
• If the panel strikes a car part during
calibration within a range of 70° inclination,
the maximum downward inclination will be
70°.
Adjusting the angle of the liquid
crystal panel
The angle of the liquid crystal panel can be
adjusted depending on the mounting angle of the
unit or light coming into the car.
1. Turn the power on. When the liquid crystal
panel is closed, press the [OPEN] button.
2. Press the [MENU] button to display the
following Menu screen:
20
VRX785BT
3. Repeat touching the [Tilt] key to adjust the
angle of the liquid crystal panel. Every
touching the [Tilt] key tilts the liquid crystal
panel forward or backward.
The adjusted angle is stored in memory.
• Adjustment is possible within the range 70°
to 110°.
• There are 5 adjustable angles available.
MAX 110°
70˚
Housing the liquid crystal panel
1. Press the [OPEN] button.
The liquid crystal panel is housed
automatically.
Note:
• When leaving this unit unused for a long period of
time or leaving your car, be sure to house the liquid
crystal panel.
Turning the liquid crystal panel
horizontal (Air conditioner operation
mode)
When the way the liquid crystal panel is mounted
hinders the operation of the air conditioner, the
position of the panel can be turned horizontal
temporarily.
1. Keep pressing the [OPEN] button more than 2
seconds when the liquid crystal panel is open.
A beep sounds and the liquid crystal panel
turns horizontal.
• Press the [OPEN] button again for the panel
to return to the original position.
• The unit can be set so that the panel returns
to the original position after a set time in the
horizontal position (see page 62).