Turning On And Off The Power; Adjusting The Volume; Opening The Liquid Crystal Panel And Adjusting The Angle - Clarion VRX785BT Owner's Manual & Installation Manual

Turning On and Off the Power

CAUTION
CAUTION
When the unit is turned on, starting and
stopping the engine with its volume raised to
the maximum level may harm your hearings.
Be careful about adjusting the volume.
Note:
• Start the engine before using this unit.
• Be careful about using this unit for a long time
without running the engine. If you drain the car's
battery too far, you may not be able to start the
engine and this can reduce the service life of the
battery.

Adjusting the Volume

1. Press the [VOL –]/[VOL +] buttons to adjust
the volume.
[VOL –]: Decreases the volume.
[VOL +]: Increases the volume.
• The volume level indicated in the display is
in a range from 0 (min.) to 33 (max.).
Opening the Liquid Crystal Panel and Adjusting the
Angle
WARNING
• To prevent the battery from going dead,
operate this unit with the engine running
if possible.
• When the liquid crystal panel is
operating, be careful not to get your hand
or finger caught between the panel and
main unit or the instrument panel of the
car.
• Do not move the liquid crystal panel by
hand.
1. Start the engine. The power is supplied to this
unit.
2. Press the [SRC] button. The unit
automatically memorizes its last operation
mode and will automatically switch to display
that mode.
3. To turn off the power, press and hold the
[SRC] button for more than 1 second.
• When Auto Panel is set to "ON" or "Close",
the liquid crystal panel houses after the
power turns off.
CAUTION
CAUTION
While driving, keep the volume level at which
external sounds can be heard.
Standing up the liquid crystal panel
1. Press the [OPEN] button.
The liquid crystal panel comes out and stands
up automatically.
Engine ON
position
19
VRX785BT