Setting The Beep - Clarion VRX746VD Owner's Manual & Installation Manual

Basic Operations
2-ZONE: 2 (rear monitor lock)
1. Press the [ADJ] button to display the
ADJUST MODE menu.
2. Touch the [MONITOR] key.
3. Touch the [REAR MONI LOCK] key and the
[ON] key.
GLock system monitor image and sound
Visual connection
(∗1)
Front image Image of device
(receiver connected to the
screen) Visual terminal
(∗3)
Rear monitor Displays image of mode selected
image using the [FUNC] button (∗2)
(separately
sold)
Vehicle speaker Plays sound of mode selected using the [FUNC] button
sound
∗1 A device connected to the Visual terminal should be set up as described in the section "Switching
CONNECT."
∗2 No image is displayed on the rear monitor when a non-image mode such as radio, CD, etc. is
engaged.
∗3 For safety reasons, this image is not displayed when the vehicle is moving. The picture can be
watched only when the vehicle is standing still and the parking brake is engaged.
Adjusting the GENERAL

Setting the BEEP

∗ The sound heard when you make operations is
called "beep". The unit can be set up so that it
does not produce this beep sound.
∗ The factory default setting is "BEEP ON".
1. When the panel is open, press the [ADJ]
button to select the ADJUST MODE menu.
2. Touch the [GENERAL] key.
Touch the [BEEP] key to select "ON" and
"OFF".
3. Touch the [RTN] key, [ESC] key, or press the
[ADJ] button.
28
VRX746VD
Front monitor lock
Visual connection
[OTHERS] [NAVI]
Image of device
connected to the
Visual terminal
4. Touch the [RTN] key, [ESC] key, or press the
[ADJ] button.
5. To cancel the monitor lock, press [ADJ]
button, touch the [REAR MONI LOCK] key
and the [OFF] key.
6. Touch the [RTN] key, [ESC] key. or press the
[ADJ] button.
The monitor lock is now canceled.
Rear monitor lock
Visual connection
[OTHERS]
Displays image of mode selected
using the [FUNC] button
Image of device connected to the
Visual terminal
Setting the button illumination
∗ The factory default setting is "GREEN" (green).
1. When the panel is open, press the [ADJ]
button to select the ADJUST MODE menu.
2. Touch the [GENERAL] key.
3. Touch the [KEY ILLUMI] key to select "RED"
(red) or "GREEN" (green).
4. Touch the [RTN] key, [ESC] key, or press the
[ADJ] button.
Visual connection
[NAVI]