Removing The Main Unit; Cautions On Wiring - Clarion VRX746VD Owner's Manual & Installation Manual

6.

REMOVING THE MAIN UNIT

1. When the rear of the main unit has been
secured with the method shown in Figure 6
unfasten the special screw.
2. Remove the outer escutcheon.
3. Insert the hook plate between the spring and
the universal mounting bracket, fit tab B of
the spring into hole A of the hook plate, then
Universal mounting bracket
2-Hook plate
Outer escutcheon
7.

CAUTIONS ON WIRING

1. Be sure to turn the power off before wiring.
2. Be particularly careful where you route the
wires.
Keep them well away from the engine, and
exhaust pipe, etc. Heat may damage the
wires.
3. If the fuse should blow, check to see if the
wiring is correct.
If it is, replace the fuse with a new one with
the same amperage rating as the original
(15A FUSE).
4. To replace the fuse, remove the old fuse of
the power supply lead and insert the new
one. (Figure10)
pull the main unit out by the hook plate.
(Insert both the right and left edges of the
hook plate.) (Figure 9)
Note: Keep the hook plate. You cannot remove the
main unit without disengaging the hook plate.
Instrument panel
Main
Unit
A B
Figure 9
Note: There are various types of fuse holder. Do
not let the battery side touch other metal
parts.
After the connection, fix the lead by a clamp or
insulation tape for protection.
Fuse holder
Spring
CAUTION
Fuse (15A FUSE)
Figure 10
VRX746VD
63