Intermec SF51 User Manual page 40

Chapter 3 — Troubleshooting and Maintaining the SF51
Problems and Possible Solutions (continued)
Problem
You are trying to
establish a Bluetooth
connection from a host
device to your SF51,
but the host device
cannot find your SF51.
When you press the
Scan button, the red
scanner beam does not
turn on.
You changed the
Bluetooth PIN from its
default value of 0000,
but you forgot your
new PIN number.
You established a
Bluetooth connection
with an Intermec
computer, and the
settings on your SF51
were restored to their
default values.
26
Possible Solution
The SF51 may not be in a discoverable state.
For help, see "Bluetooth Discoverable" on
page 39.
The SF51 may be connected and paired to
another Bluetooth device. Scan the following
bar code to reset the SF51 to its default
settings and disconnect Bluetooth
communications. Try establishing a
connection again.
Administrator Reset Factory Defaults
\60\08\55\22
Note: Using the Administrator Reset Factory
Defaults command resets all settings. As a
result, you will lose Bluetooth
communications.
The battery is low. Charge the battery
immediately and try scanning again.
Scan this bar code to reset the scanner to its
default configuration and default Bluetooth
PIN of 0000.
Administrator Reset Factory Defaults
\60\08\55\22
When you connect to an Intermec computer,
all SF51 settings that are common to the
Intermec computer's internal scanner settings
are changed to the default settings of the
internal scanner. Scan configuration bar
codes, or use Intermec Settings on your
Intermec computer to change your SF51
settings.
SF51 Cordless Scanner User's Guide