Connecting To An Intermec Computer - Intermec SF51 User Manual

Connecting to an Intermec Computer

Note: When you connect to an Intermec computer,
all SF51 settings that are common to the Intermec
computer's internal scanner settings are changed to
the default settings of the internal scanner.
1 Install EasySet version 5.4 or later on a host PC. EasySet is
available on the CD that shipped with the SF51 or from the
Intermec web site at www.intermec.com.
2 Start EasySet. Make sure that SF51 is selected as your
product.
3 From the EasySet commands window, select Data
transmission settings > Bluetooth parameters > connect/
disconnect.
4 Double-click compose BT address.
5 Enter the Bluetooth address of your Intermec computer and
click OK. The bar code appears on the setup sheet.
6 Scan the bar code onscreen with the SF51, or print the bar
code setup sheet and scan the bar code.
The SF51 beeps once, the green status light flashes once, and
the blue Intermec Ready-to-Work indicator starts blinking.
On your Intermec computer, the Authen. Request dialog box
appears.
7 In the Enter PIN field, enter the default PIN (0000) and
select OK.
When the SF51 connects to your Intermec computer, the
SF51 emits a series of beeps from low to high, and the blue
Intermec Ready-to-Work indicator turns on and stays on. The
SF51 is ready to scan data.
Note: To connect more than one SF51 to your
Intermec computer, use the Bluetooth Device Utility
or the Bluetooth control panel on the Intermec
computer. For help, see the documentation for your
Intermec computer.
SF51 Cordless Scanner User's Guide
Chapter 2 — Connecting and Configuring the SF51
13