R.V.R. Electronica PJ700C-LCD User Manual page 18

PJ500C-LCD, PJ700C-LCD & PJ1000light
When the display is off, touching any key will turn on backlighting.
When the display is on, pressing the ESC button (chap. 6.1) from the default
menu (menu 1) calls up the selection screen (menu 3), which gives access to
all other menus:
To gain access to a submenu, select menu name (name is highlighted by cursor)
using button
Press ESC again (chap. 6.1) to return to the default menu (menu 1).
5.4.1 Operation Menu (Fnc)
In this menu, you can set power output On/Off, toggle between "Local" or "Remote"
control mode and set the Forward Power Good (PgD) threshold rate.
To edit an item, highlight the appropriate line using the UP and DOWN buttons and
then press and hold the ENTER button (chap. 6.1) until the command is accepted.
This way, Pwr setting is toggled between On and Off and Mod setting is toggled
between "x1" and "x10". To edit the Power Good rate, simply select item "PgD"
and edit its value using buttons
6.1).
Pwr
Loc
14 / 32
or and press the ENTER button (chap. 6.1).
Enables (ON) or disables (OFF) amplifier power output.
Modifies machine operation. In the LOCAL mode, the machine can read
and modify its operating parameters through the navigation keys and the
management firmware, whereas all other sources are locked out. In the
REMOTE mode, the machine can only read its operating parameters;
parameters are modified based on the commands received from other
connected telemetry systems.
Rev. 1.0 - 20/06/08
Menu 3
and ; finally, press ENTER to confirm (chap.
Menu 4
User Manual