Clarion pro audio vrx 630 Owners & Installation Manual page 25

Setting the TV diver
This function is enabled only when the panel is
open.
Normally use the TV diver with the "ON" position.
You can change the reception setting for the TV
antenna connected to the TV tuner.
1. Press the ADJ button * to switch to the ad-
justment selection display.
2. Operate the JOYSTICK ¡ upward or down-
ward to select "TV DIVER".
3. Operate the JOYSTICK ¡ rightward or left-
ward to select "ON" or "OFF" and press the
ENT at the center of the JOYSTICK ¡ to set
the selected reception setting.
ON:
Sets reception emphasizing the visual.
OFF:
Sets the diver setting to OFF.
4. Press the ADJ button * to return to the pre-
vious mode.
Adjusting the brightness and tone
of color
Notes:
• This operation is available only when the car is
stopped and the parking brake is applied.
• This function is not available when the display is
stored.
• The HUE setting can be adjusted only when the
NTSC mode is selected.
1. Press the BND button % to switch to the ad-
justment selection display.
2. Operate the JOYSTICK ¡ upward or down-
ward to select the option "MONI ADJ" (by mov-
ing the cursor).
3. Press the ENT at the center of the JOYSTICK
¡.
4. Operate the JOYSTICK ¡ rightward or left-
ward to select "BRIGHT","COLOR" or "HUE"
(by moving the cursor).
"BRIGHT":
Adjust the brightness of the display.
"COLOR":
Adjusts the color saturation.
"HUE":
Adjusts the tone of color (red is emphasized
or green is emphasized.)
5. Operate the JOYSTICK ¡ upward or down-
ward to adjust a level.
6. When the adjustment is made, operate the
JOYSTICK ¡ rightward or leftward to move
the cursor to "MENU". Then press the ENT at
the center of the JOYSTICK ¡ to return to
the adjustment selection display.
Changing over display size
This function is available only when the panel is
open.
Notes:
• This function is not available while you are driving.
• Switch to the VTR/TV/DVD video mode you see.
1. Press the WIDE button 7 to change over the
monitor display size. Each time you press
the WIDE button 7, the monitor display size
changes in the following order:
"NORMAL" "WIDE"
"CINEMA" "NORMAL"
"NORMAL": (normal display)
There is a black area at both right and left
ends of a display. In case of normal TV
broadcasting (4:3), the image can be shown
without being cut or deformed.
"WIDE": (wide mode)
The image at right and left ends in a display
elongates horizontally.
"F. WIDE": (full wide mode)
The whole image elongates horizontally.
"CINEMA": (cinema mode)
The image at both top and bottom in a dis-
play disappears.
Notes:
• When a normal 4:3 size image, not being a wide
one, is viewed by displaying it fully on a wide moni-
tor display in a wide mode or a full-wide mode, a
part of the peripheral image will be lacking or de-
formed. In deference to the intention of producer,
an original image can be viewed in a normal mode.
• During superimposed display, it becomes a full-wide
mode.
TV Operations
"F. WIDE"
29
VRX630