Chapter 4: Using The Tcp/Ip Features; Tcp/Ip Connections - RabbitCore RCM2000 Series Getting Started Manual

C-programmable module with ethernet

Hide thumbs Also See for RCM2000 Series:

Table of Contents

4. U

Before proceeding you will need to have the following items.

• If you don't have Ethernet access, you will need at least a 10Base-T Ethernet card

(available from your favorite computer supplier) installed in a PC.

• Two RJ-45 straight through Ethernet cables and a hub, or an RJ-45 crossover Ethernet

cable.

The Ethernet cables and Ethernet hub are available from Z-World in a TCP/IP tool kit.

More information is available at www.zworld.com.

1. Connect the AC adapter and the programming cable as shown in Chapter 2, "Hardware

Setup."

2. Ethernet Connections

If you do not have access to an Ethernet network, use a crossover Ethernet cable to con-

nect the RCM2200 board to a PC with at least a 10Base-T Ethernet card.

If you have Ethernet access, use a straight Ethernet cable to establish an Ethernet con-

nection to the RCM2200 from an Ethernet hub.

The PC running Dynamic C through the serial port on the RCM2200 does not need to

be the PC with the Ethernet card.

3. Apply Power

Plug in the AC adapter. The RCM2200 is now ready to be used.

Getting Started

TCP/IP F

SING THE

EATURES

Table of Contents

Need help?

Do you have a question about the RCM2000 Series and is the answer not in the manual?

Rcm2200