Installation Options; Installation When Operating With Tripod / Mast Systems - Seto ALDEBARAN 360 GRAD FLEX-C 2.0 Instructions For Use Manual

1. Installation when operating with tripod / mast systems

INFORMATION!
• The luminaire can be operated on various mast / tripod systems.
A mast mount is available on the luminaire for this purpose. The
mount is suitable for a DIN bolt (d = 30 mm).
• The luminaire may only be operated in connection with a tripod /
mast system which is equipped with a standard pin according to
DIN 14640.
• Operation of the luminaire is only permitted up to a maximum
wind speed of 100 km/h.
Safe operation cannot be guaranteed in stronger winds.
Connect the luminaire to the bolt receiver (C) and the tripod / mast system.
Lock the ALDEBARAN® 360 GRAD FLEX-C 2.0 using the star grip (B).
ATTENTION!
• Make sure the tripod / mast system can support the weight of the luminaire. For safe operation, the instructions
for the tripod / mast system must be observed.
• The ALDEBARAN® 360 GRAD FLEX-C 2.0 requires room / ambient air for proper operation. The luminaire must be
installed free-standing with at least 0.5 m clearance on all sides.
• Make sure that the active cooling (fan) is not affected by dirt.
WARNING! Risk of injury!
• When operating with a tripod or mast, it must also be ensured that this is sufficiently stable. It is important to ensure
that it is on a level surface. Inclinations are to be avoided.
• Be sure to fix the luminaire with the star grip after it has been placed on your mast / tripod system. This is how you
avoid accidents.
2. Hanging operation
The luminaire can also be operated hanging. This is only permitted in connection with the optional accessory (item no.:
1410926021). For this, the ring nut (A) is to be used as a fastening.
ATTENTION!
Make sure your suspension point can support the weight of the luminaire.
14

Installation options