Table of Contents
Advertisement
When you are done riding or in case of an emergency, pull the kill switch
to turn off the bike.
ALWAYS wear the kill switch strap around your wrist when riding. This is to
prevent further damage to the rider, the vehicle or other property. When falling,
losing control or feeling unsafe, release your right hand from the handlebar
and pull it back, this will disconnect the kill switch and turn the bike off.
ALWAYS disconnect the kill switch when not riding. As the bike makes no noise
when on standby mode, it's impossible for bystanders to know if the bike is
on or not. This can cause accidents if people are pulling the throttle while
expecting a turned off bike.
Dashboard
The dashboard on the stem is the bikes control panel. Here you can see the
bikes SOC (state of charge), Ride mode, Brake mode and warning notifications.
State Of Charge indicator
The application also contains Battery SOC estimator, which estimates SOC of
the battery using an algorithm. SOC is displayed with 4 LEDs on the dashboard.
100% -80%
80% - 60%
60% - 40%
40% - 20%
20% - 10%
10% - 0%
Initialization procedur
Controller is getting information from battery during initialization procedure.
This state is indicated by gradually increasing white LEDs on dashboard.
There are two special states, in which initialization color change from white
to yellow or orange. These information is showed after startup for hours
specifed in parameter serdur.
Advertisement
Table of Contents
