Table of Contents
Advertisement
Kill switch
The kill switch is located on the right side of the handlebar. When the kill
switch is connected with the magnet, the bike is activated. When you are
done riding or in case of an emergency, pull the kill switch to turn off the bike.
ALWAYS wear the kill switch strap around your wrist when riding. This is to
prevent further damage to the rider, the vehicle or other property. When falling,
losing control or feeling unsafe, release your right hand from the handlebar
and pull it back, this will disconnect the kill switch and turn the bike off.
ALWAYS disconnect the kill switch when not riding. As the bike makes no
noise when on standby mode, it's impossible for bystanders to know if the
bike is on or not. This can cause accidents if people are pulling the throttle
while expecting a turned off bike.
2.4 Charging
When charging the bike, do the following steps. ALWAYS read the charging
manual before charging.
1. Make sure that the battery is connected to the bike.
2. Disconnect the kill switch.
3. Turn on the master switch (pointing forwards).
4. Make sure that your chargers voltage settings corresponds to the voltage in
your outlet. If the charger has the wrong settings, it will break. If you're
unsure on what voltage you use in your country, try a Google search or
calling your electric utility provider.
5. Plug the charger into the outlet.
6. Plug the charger into the bike (charger connector can be found on the right
motor fender, or directly on the battery which is accessed by removing
the seat). Take away the protective plug on the charger connector by
pressing the silver button on top while pulling on the plug. When the
charger is connected, it will show a red light. When the charging is done,
it will light in green. Don't forget to put in the protective plug in the
connector to avoid any dirt inside.
Advertisement
Table of Contents
