Table of Contents
Advertisement
Removing the battery pack
Use a hex key in order to remove the 2 screws that's holding the battery pack
down. When removed, put away the 2 screws nearby. There are two steel
rods holding the battery in place, make sure to lift the battery straight up
using both hands. Note that the battery pack is heavy, and you might want
the help of a friend to assist.
When mounting the battery in the bike, make sure that there's no dirt or objects
on the battery rubber floor or where the connectors are. This can cause the
battery to not connect properly. Look through the holes in the battery pack
making sure that you match up the holes and the metal rods before gently
sliding it down. Use help of a friend if needed.
Disconnect the black 8 pin connector on the top of the battery by unscrewing
the latch on the connector and pull the battery apart.
When connecting the battery connector again, make sure that the connector
from the bike is stowed away so it is not squeezed between the battery and
the battery compartment.
When connecting the black 8 pin connector, the grove on the inside of the
connector should align with the mating connector before connecting them,
proceed by screwing the the latch on the battery connector to lock them
together.
When you don't have the battery inside the bike, always be careful handling
the battery. If dropped, inspect it visually and get in contact with a CAKE
employee if there's any damage to it.
Slide the seat on and make sure that the metal tongue gets full contact with
the pin without any cables getting in the way. Before screwing on the 2 bolts
in the rear seat, make sure that the seat has good contact with the carbon
frame, both in the front and on the side.
Advertisement
Table of Contents
