Automatic Switch-Off; Switching Off; Cleaning And Maintenance - Beurer HK 48 Cosy Instructions For Use Manual

4.5 Automatic switch-off

This heat pad is equipped with an automatic switch-off function. This turns off the heat sup-
ply approx. 90 minutes after the initial use of the heat pad. The temperature setting display
then starts to flash. So that the heat pad can be switched back on, the slider for ON/OFF and
temperature settings (5) must first be set to setting "0" (OFF). After about 5 seconds it is pos-
sible to switch it on again.

4.6 Switching off

To switch the heat pad off, set the slider for ON/OFF and temperature settings to setting "0" (OFF). The
temperature settings are then no longer illuminated.
NOTE:
If the heat pad is not in use, switch the side slider for ON/OFF to setting "0" (OFF) and unplug the power
plug from the socket. Then disconnect the control from the heat pad by unplugging the plug-in coupling.

5. Cleaning and maintenance

WARNING
Before cleaning, always remove the power plug from the socket first. Then disconnect the control from
the heat pad by unplugging the plug-in coupling. Otherwise there is a risk of electric shock.
CAUTION
The control must never come into contact with water or other liquids, as this may cause damage.
• To clean the control, use a dry, lint-free cloth. Do not use any chemical or abrasive cleaning agents.
• The heat pad consists of the cover with integrated heat pad (outside) and the inner pad. Always remove
the inner pad before cleaning. To do this undo the zip fastening.
CAUTION
The inner pad is not washable.
• Small marks on the cover with integrated heat pad can be removed with a damp cloth and a small amount
of mild liquid laundry detergent.
• The cover with integrated heat pad is machine-washable. For ecological reasons, always wash it together
with other textiles.
• Set the washing machine to a particularly gentle wash cycle at 30°C (wool cycle). Use a mild laundry de-
tergent and measure it out according to the manufacturer's instructions.
CAUTION
Please note that frequent washing of the cover with integrated heat pad will adversely affect the
product. It should therefore be washed in a washing machine a maximum of 10 times during its life.
CAUTION
Please note that the cover with integrated heat pad must not be dry cleaned, wrung out, tumble
dried, put through a mangle or ironed.
Immediately after washing, reshape the cover with integrated heat pad to its original dimensions
while it is still damp and spread it out flat on a clothes horse to dry.
15
90
min
STOP