CAMBRIONIX PowerPad8S User Manual page 24

CAUTION
. Do not interrupt the Firmware update process
l
. Do not disconnect the power during the update process
l
( Command Line Instructions (CLI 5.5.7
Command Line Instructions can be used to control and monitor the functions of the
hub and attached devices. To use the command-line interface a serial terminal emulator must
be installed on the host computer. Examples include Serial, ZTerm, PuTTy, and Minicom. If you
would like more information, please look at our more in-depth information here:
www.cambrionix.com/cli
Two example commands can be seen below, you can use these commands to check hub
. information and health
Action Command
Show hardware and firmware information system
Show voltages, temperatures, errors and boot
health
flag
Page 23 of 38 PP8S