Table of Contents
Advertisement
S
Chapter Tip: To set up your JNSGyro-2T system, configure the JNSGyro-2T
boards as described in Chapter 2 "Configuration".
How to Work with JNSGyro-2T
Real-Time Heading
www.javad.com
ETUP AND
The heading mode is a part of the standard firmware and is activated by
commands. One needs two receivers interconnected through the serial ports.
One of them is a moving base (MB) and another is a rover (R). JNSGyro-
2T combines both boards connected internally in one unit.
Say, both receivers are interconnected through the ports B. Then the scripts
for receivers to operate at 5 Hz are:
1. For Moving base:
set,rover/mode/,off
set,base/mode/,off
M
EASURING
3
JNSGyro-2T Operator's Manual 41
Advertisement
Table of Contents
Need help?
Do you have a question about the JNSGyro-2T and is the answer not in the manual?