Wall Holding; Operating Elements; Lcd Display - ABSINA WALLBOX Operating Manual

8. WALL HOLDING

The wallbox may only be screwed to walls with an
appropriately firm base. Pay attention to cables that
may run in the wall.
1. Mark 2 drill holes in a suitable place using the wall
bracket.
2. Drill two 6mm holes and insert the enclosed dowels.
3. Screw the wall bracket to the wall using 2 of the
4x40mm screws provided.
4. Then screw the securing plate to the wallbox using 2
M3x10 metric screws.
5. Then hang the wallbox on the wall bracket and mark
the drill hole for screwing the securing plate to the
wall.
6. Remove the wallbox from the bracket, drill a 6mm
hole at the marked location and insert the enclosed
dowel.
7. Now you can hang the wallbox on the wall bracket
and screw the securing plate with the 4x40mm
screw.
Securing plate
Wall bracket
Deutsch . English

9. OPERATING ELEMENTS

10. LCD DISPLAY

7
15
8
9
13 14
7. Temperature display (internal temperature)
8. Display supply voltage in V
9. Current charging capacity in kW
10.Charging time
11. Current charging current in amperes (only for 3-
phase charging)
12.Charged energy in kWh (only with 3-phase
charging). This value is not saved after the loading
process is finished.
13.Set charging current in amperes (Note: The charging
current is regulated by the OBC in the car and may
therefore be below the set maximum value à for
actual charging see point 11)
14.Time preselection charging start
1. Charging indicator
2. Emergency stop switch
3. LCD display
4. Sensor button for
charging current setting
5. Sensor key for start
preselection
6. RFID receiver
10
11
12