Electrolux IK285SAR User Manual page 21

Problem
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
DEMO appears on the dis‐
play.
A or or symbol is
shown instead of numbers
on the temperature dis‐
play.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
Possible cause
The "FastFreeze function"
or "FastCool function" is
switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been opened
often.
The FastFreeze function is
switched on.
The FastCool function is
switched on.
The appliance is in demon‐
stration mode.
Temperature sensor prob‐
lem.
8.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
ENGLISH
Solution
Switch off "FastFreeze
function" or "FastCool
function" manually, or wait
until the function deacti‐
vates automatically to set
the temperature. Refer to
"FastFreeze function" or
"FastCool function" sec‐
tion.
Set a higher/lower temper‐
ature.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if nec‐
essary.
Refer to "FastFreeze func‐
tion" section.
Refer to "FastCool func‐
tion" section.
Keep the OK key pressed
for approximately 10 sec‐
onds until a long sound is
heard and the display turns
off for a short time.
Contact the nearest Au‐
thorized Service Centre
(the cooling system will
continue to keep food
products cold, but temper‐
ature adjustment will not
be possible).
21