Dimplex everdri 20 E Instruction Manual page 11

Drainage
While the water tank is full, the compressor will stop for self-protection and the water
tank full indicator light will turn red.
To move the water tank, pull it out squarely from the unit.
After empting the water tank, place the water tank carefully back into its location into
space. The tank must be properly located in order for the 'water full' light to go out
and for your dehumidifier to start operating again.
Please note, if the water tank has not been positioned/located correctly, the water full
indicator will stay red and the product will not operate.
Continuous drainage
When the dehumidifier is operated at very high humidity levels, the water tank will
require more frequent emptying. In this situation, it may be more convenient to set the
unit up for continuous drainage, this can be done as follows:
1. Pull out the water tank.
2. Connect a water drain tube of inner
diameter 11 mm to the drain spout
connection outlet at the top of the
tank location area.
* Please note, the water tube is not supplied
with the unit.
3. Ensure the drain tube is fixed properly
and that water will always drain away
freely through the tube (the drain
point/open end of the tube must be
at a lower height than the drain outlet
from the product).
Note! In very cold weather conditions,
precautions should be taken to prevent the
water tube from freezing.
4. Put the water tank back to its position.
11
Water drain tube
with 11mm internal
diameter