Installation; Fitting The Oven Into The Kitchen Unit - Daniela DAN5TFS User Manual

60cm built in 5 function electric oven
Table of Contents

Advertisement

Do not use oven door as a shelf, bench or seat, and make sure that children are not able
neither to climb nor sit on it.
Do not push down on the open oven door.
Before using your new oven run the oven at 200°C while it is empty for approximately 15
minutes. Please ensure you heat each element in the oven before use.
Note, that when first using the oven, ensure that the room is well ventilated (e.g. open a
window or use an extractor fan) and that persons who may be sensitive to the odour avoid
any fumes. It is suggested that any pets be removed from the room until the smell has ceased.
The appliance and the accessible parts of it will become hot during use. Be careful not to
touch the heated elements. Children must not be allowed to touch the appliance, unless
they are supervised continually.
Only a qualified person in compliance with the instructions provided must install the
appliance. The appliance must be fully assembled as in normal operation without any parts
removed. Daniela Appliances Pty Ltd declines all responsibility for improper installation,
which may harm persons and animals and damage property.
Ensure that the appliance is switched off before undertaking any maintenance,
by switching off the main switches and turning all knobs to "OFF" position.

FITTING THE OVEN INTO THE KITCHEN UNIT

Fit the oven into the space provided in the kitchen unit; it may be fitted underneath a work top
or into an upright cupboard. Fix the oven in position by screwing into place, using the two fixing
holes in the frame. To locate the fixing holes, open the oven door and look inside.
To allow adequate ventilation, the measurements and distances adhered to when fixing the oven.
For the most efficient air circulation, the oven should be fitted according to the dimensions
shown in Fig. 1 and 2
The rear panel of the cabinet must be removed so that air can circulate freely
The panel to which the oven is fitted should have a gap of at least 70mm at the rear.
P
I
02 9604 1226
E
I
WARNING

INSTALLATION

sales@danielaappliances.com.au
W
|
danielaappliances.com.au
PA G E 7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents