Fitting The Appliance - Daniela DAN5TFS User Manual

60cm built in 5 function electric oven

Hide thumbs

Table Of Contents

Table of Contents

•

Fit the appliance into the cavity and secure by inserting the screws and plastic caps into the

2 holes that can be seen in the frame of the oven when the door is open.

•

For the most effective air circulation, the oven should be fitted according to the dimensions.

•

Please measure the original product to ensure that the cut-out details are correct.

•

The rear panel of the cabinet must be removed so that air can circulate freely.

•

The panel to which the oven is fitted should have a gap of at least 70mm at the rear.

•

If the appliance it to be installed directly to the mains, fixed wiring should be as follows:

The "yellow/green" earth wire, which must be connected to terminal, has to be about

10mm longer than the other wires; the "blue" neutral wire has to be connected to the

terminal marked with letter N. "Black, brown, red" live wires have to be connected to

terminal L. Mains connection can also be made by fitting a double pole switch with a

minimum gap between the contacts of 3mm, proportionate to the load and complying

with the regulations in force.

Pole switch used for mains supply connection should be easy to get at, once the

appliance is in position.

IMPORTANT

•

Position the mains supply cable so that it is never subjected to a temperature which is more

than 500 above ambient temperature.

•

The electrical safety of the appliance can only be guaranteed when it has been

correctly connected to an efficient earthed power supply, as laid down in the regulations

for electrical safety.

•

The manufacturer cannot be held responsible for any damage to persons or objects due to

lack of an earth connection.

02 9604 1226