Hilti SF 6-A22 Manual page 24

Trouble or fault
SF 6H-A22
Hammer drilling is not possi-
ble.
The control switch can't be
pressed, i.e. the switch is
locked.
The drill / driver or the battery
gets very hot.
8 Disposal
WARNING
Risk of injury. Hazards presented by improper disposal.
▶ Improper disposal of the equipment may have the following consequences: The burning of plastic
components generates toxic fumes which may present a health hazard. Batteries may explode
if damaged or exposed to very high temperatures, causing poisoning, burns, acid burns or
environmental pollution. Careless disposal may permit unauthorized and improper use of the
equipment. This may result in serious personal injury, injury to third parties and pollution of the
environment.
▶ Dispose of defective batteries right away. Keep them out of reach of children. Do not disassemble
or incinerate the batteries.
▶ Batteries that have reached the end of their life must be disposed of in accordance with national
regulations or returned to Hilti.
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
In accordance with the European Directive on waste electrical and electronic equipment and its implemen-
tation in conformance with national law, electric tools or appliances that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.
▶ Disposal of electric tools or appliances together with household waste is not permissible.
9 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
10 EC declaration of conformity
Manufacturer
Hilti Aktiengesellschaft
Feldkircherstrasse 100
9494 Schaan
Liechtenstein
We declare, on our sole responsibility, that this product complies with the following directives and standards.
Designation
Type designation
Generation
20
Possible cause
The operating mode is not set cor-
rectly at the selector ring.
The forward/reverse selector
switch is in the middle (transport)
position.
Electrical fault.
The drill / driver is overloaded (ap-
plication limit exceeded).
Drill/driver
SF 6-A22
01
Action to be taken
▶ Set the selector ring to the
"Hammer drilling" position
▶ Push the forward/reverse switch
to the left or right.
▶ Switch the drill / driver off
immediately, remove the battery
and contact Hilti Service.
▶ Check the application.
.