Electrolux IK277BN User Manual page 15

Problem
Audible or visual alarm is
on.
A square symbol is shown
instead of numbers on the
Temperature Display.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FastFreeze
Shopping, or after chang‐
ing the temperature.
Water flows on the rear
plate of the refrigerator.
Possible cause
The cabinet has been re‐
cently switched on.
The temperature in the ap‐
pliance is too high.
The door is left open.
Temperature sensor prob‐
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products to be
frozen were put in at the
same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The FastFreeze function is
switched on.
The Shopping function is
switched on.
This is normal, no error
has occurred.
During the automatic de‐
frosting process, frost
melts on the rear plate.
ENGLISH
Solution
Refer to "Door Open
Alarm"or "High Tempera‐
ture Alarm".
Refer to "Door Open
Alarm"or "High Tempera‐
ture Alarm".
Close the door.
Contact the nearest Au‐
thorized Service Centre
(the cooling system will
continue to keep food
products cold, but temper‐
ature adjustment will not
be possible).
Close and open the door.
Contact the nearest Au‐
thorized Service Centre.
Refer to "Operation" chap‐
ter.
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature be‐
fore storing.
Refer to "Closing the door".
Refer to "FastFreeze func‐
tion".
Refer to " Shopping func‐
tion".
The compressor starts af‐
ter a period of time.
This is correct.
15