Response To Emergency Situations; Product Overview; General Remarks - AEG AS-BBH1-10000/HV Series Installation Manual

High voltage battery
Table of Contents

Advertisement

Before attempting maintenance, disconnect
10min
first all power supplies from the grid to the energy
storage system. Disconnect the breakers. Wait at least
5 minutes until the internal parts of the system are
discharged.
Please follow the electrostatic protection norms,
and take correct protective measures as there are
electrostatic sensitive circuits and devices in the
system. Appropriate protective measures are meant to
prevent damages to the product and personal injury.
Only use original parts and components. Do not
refit the energy storage system unless authorized.
Do not get near to / touch any metal conductive
part of the grid or of the high voltage battery, otherwise
electric shock, physical injury, death or fire may occur.
Always pay attention to warning icons and instructions
signaling the possibility of electric shock.
Do not use cleaning solvents to clean the battery pack.

2.6 Response to emergency situations

The battery pack is designed to prevent hazards
resulting from failures. However, Solar Solutions cannot
guarantee for its absolute safety.
If the battery pack leaks electrolyte, avoid contact
+ _
with the leaking liquid or gas. Electrolyte is corrosive
and contact with it may cause skin irritation and
chemical burns.
If you find yourself in any of the below emergency
situations resulting from exposure to electrolyte, please
take the suggested take promptly:
Inhalation: evacuate the contaminated area, and
immediately seek medical attention.
Eye contact: rinse the eyes with flowing water for 15
minutes, and immediately seek medical attention.
Skin contact: wash the affected area thoroughly
with soap and water, and seek immediately medical
attention.
Ingestion: induce vomiting, and seek immediately
medical attention
AEG HIGH VOLTAGE BATTERY (10 KWH / 15 KWH) INSTALLATION MANUAL
Fire: in case of fire, always have an ABC or carbon
dioxide extinguisher at hand.
The battery pack may catch fire if heated above
150°C. If a fire breaks out when the battery pack is
installed, proceed with the following actions:
Extinguish the fire before the battery pack catches
fire.
If it is impossible to extinguish the fire but you still
have time, move the battery pack to a safe area
before it catches fire.
If the battery pack has caught fire, do not try to
extinguish the fire. Evacuate people immediately.
If the battery catches fire, it will produce noxious
and poisonous gases. Do not get close to it.
Wet battery: if the battery pack is wet or submerged
in water, do not try to get close to it. Contact your
installer/ dealer for technical assistance.
Damaged battery: damaged batteries are dangerous
and must be handled with extreme caution. They are
not fit for use and may pose a danger to people or
property.
If the battery pack seems to be damaged, pack it in its
original container, and then return it to your installer or
distributor.
Damaged batteries may leak electrolyte or
+ _
produce flammable gas. If you suspect such damage,
immediately contact your installer/ dealer for advice
and information.

3. PRODUCT OVERVIEW

3.1 General remarks

The AEG high voltage battery AS-BBH1-xxx-/HV
(xxx= 10000 or 15000) is a lithium battery product
with BMS (Battery Management System) developed for
use with photovoltaic installations.
Characterized by high energy density and reliability,
the battery pack's safety is granted among others by
relevant protection functions such as under-voltage,
over-voltage, over-current, over-temperature, under-
temperature protection. The battery pack further
supports CAN communication and features a WiFi
connection module The number of battery units can be
6
EN
PD202209 V2-1-22

Advertisement

Table of Contents
loading

This manual is also suitable for:

As-bbh1-15000/hv series

Table of Contents