Table of Contents
Advertisement
The unmarked terminals are for connecting a small
light. The light used should not exceed 100mA of
current draw. A 12 volt LED, available from Radio
Shack®, works well. This light is a remote of the
light on the unit. The light may be useful to help
determine the best settings during initial testing,
then removed. The details of this will be covered
later in this manual.
It is recommended to check the static timing before
and after the installation. The static timing should
not vary by more than a degree or so. If the timing
does change then there may be a problem, and the
unit should be disconnected.
The design of the system allows for it to be
connected or disconnected with the engine running
if needed.
However this is not recommended, as this could
result in severe electrical shock if the magneto is
running.
If a problem is suspected then the unit can simply be
disconnected from the kill wire leaving the engine in
original form. Disconnecting the power supply
should also deactivate the system.
8
Davis Technologies TMS-5500-SL Elec Points
www.moretraction.com
Advertisement
Table of Contents
