Advertisement
Quick Links
Sunbird
V2.0 Balsawood Airplane
Preparation Tool
1.Fuselage Assembly
1.2
F1
1.3
F14
F15
1.4
1.5
F6
F7
All manuals and user guides at all-guides.com
Paste the F1 and F2 together,and
fasten the joint with F3.
F2
F3
F19
3*4mm balsa strips
Paste the F5 and F6 together,and
fasten the joint with F7.
Instruction Manual
Wingspan: 1600mm
Speci�ication
Length: 850mm
Flying Weight≈450-650g
Accessories include
F5
Motor: MM2212 1100KV
Suggested Equipment
ESC: 20A
Propeller: 8 inch folded propeller
Servos: 9g*4
Battery: 3s 800-1300mAh
Radio≥4CH
Take down and assemble the
wood pieces of fuselage as per
the following picture,connect
the joints by 502 glue.
Cut the balsa strips with actual
length,assemble them in place
as pitcture shown left;Assemble
in the same way the other side.
Advertisement
Related Manuals for Dancing Wings Hobby Sunbird
Summary of Contents for Dancing Wings Hobby Sunbird
- Page 1 All manuals and user guides at all-guides.com Sunbird Instruction Manual V2.0 Balsawood Airplane Wingspan: 1600mm Motor: MM2212 1100KV Speci�ication Suggested Equipment Length: 850mm ESC: 20A Flying Weight≈450-650g Propeller: 8 inch folded propeller Servos: 9g*4 Battery: 3s 800-1300mAh Radio≥4CH Accessories include Preparation Tool 1.Fuselage Assembly...
- Page 2 All manuals and user guides at all-guides.com Sunbird Instruction Manual V2.0 Balsawood Airplane Paste the finished board (picture 1.5 above) at the bottom of the fuselage. Assemble the cabin cover as picture shown left. Paste the cover F4 and F8 as...
- Page 3 All manuals and user guides at all-guides.com Sunbird Instruction Manual V2.0 Balsawood Airplane Assemble the wing as per the 1:1 plan,and take care of the straightness of the wing. Paste the balsa cover onto the wing. Paste the W17 on the wing as picture shown,cut and polish by knife with curve.
- Page 4 All manuals and user guides at all-guides.com Sunbird Instruction Manual V2.0 Balsawood Airplane 3.Assembly of Wing and Fuselage Paste together the F17 and F18,assemble the nut onto the F18. Assemble the finished part (picture 3.2) onto the fuselage. Assemble the wing onto the fuselage,drill a hole on the wing as per the F17 position,finally fasten the wing with screw.