MALTEC KLP-9000KWA Instruction Manual page 34

SETTINGS
5.3.1 Start-up and Shutdown
Press POWER to turn the unit on.
Press MODE button to select the desired operation mode.
Press POWER again to turn off the power.
5.3.2 Operation mode
The unit has four operation modes: Fan, Cool, Dehumidifier, sleep.
 Cooling your room
Select the cool mode to lower the temperature in your room.
Press MODE button repeatedly until the COOL indicator lights up.
Press Up/Down button to adjust the temperature which is displayed on the screen. The
temperature can be set between 16 and 32 .
Press SPEED button repeatedly until the desired fan speed indicator lights up.
To control the direction of the air flow horizontally, please adjust the inner louver by hand.
Note ： The air conditioner stops if the room temperature is lower than selected temperature.
 Ventilating your room
Press MODE button repeatedly until the FAN indicator lights up.
In ventilation mode the room air is circulated, but not cooled.
Press SPEED button repeatedly to select the fan speed as desired.

Drying your room
Press MODE button on the control panel or remote control, the dry indicator lights up. The fan
speed is unable to select. User should connect the hose to the drain outlet at the bottom of the
unit.
Note: In this mode, the fan speed switches over to low speed and cannot be selected.
 Sleep mode
The sleep mode can be activated when in cool mode.
◦ In cool mode :
After 1 hour the preset temperature is increased by 1 , after another hour the preset
temperature will again be increased by 1 . ℃
5.3.3 TIMER SETTING（1hour-24hours）:
The timer has two ways of operation:
To turn off
(When power on)
To turn on
(When power off)
Cancel timer
5.3.4 Automatic Defrost
At low room temperatures, frost may buildup at the evaporator during operation. The unit will
automatically start defrosting and the POWER LED blinking. The defrost control sequence is as
34
℃ ℃
℃